Scalair taxi test Deelen

R&D case

R&D case: Scaled Flight Demonstrator – SFD

SCALAiR is part of Clean Sky2 Large Passenger Aircraft, and aims to validate scaled flight testing as a viable means for de-risking disruptive aircraft technologies and aircraft configurations to a high technology readiness level. The NLR activities involve ‘Test Aircraft Preparation and Qualification’ acceptance.

The challenge

The goal is to develop a highly representative scaled aircraft of an actual aircraft, equipped with very accurate flight test instrumentation to perform measurements during the tests. This will introduce a very cost-effective approach to developing radical new aircraft, as needed for more sustainable aviation.

The solution

The project has developed a Scaled Flight Demonstrator (SFD) of a scaled reference aircraft (A320, scale 1:8,5), which is representative for the full-scale aircraft at Mach 0.4. SFD flight test data is measured to show that scaled flight-testing can be used for obtaining flight-mechanics characteristics that are representative of the full-scale aircraft.

What did we do?

The work included avionics subsystem design & manufacturing & test, SFD airframe (wing & fuselage) design & manufacturing & assembly & integration (with Orange Aircraft), integration of Flight Test Instrumentation (developed by NLR), development of and integration with the Ground Control System (with CIRA), SFD system integration and test, wind tunnel tests at DNW LLF (April 2021), qualification of an operational concept to obtain an authorisation to fly, and training of the flight crew. High-speed taxi tests were performed at Deelen, the Netherlands, in November 2021

A Flight Readiness Review has been conducted successfully, with Airbus as an important reviewer. The first SFD flight as part of a qualification campaign at Deelen will be performed in the first half of 2022. The mission flight campaign in Italy is planned for mid-2022. All results will be used by ONERA to compile a final report and validate the concept of scaled flight testing as a viable means for future aircraft development

Scalair demonstrator at Orange Aircraft
NLR Marknesse

Information

Latest cases

Construction and Manufacturing

28 May 2025

R&D case: Penelope

Penelope: Fast Non-Destructive Testing of Large Composite Aircraft Structures Automation of non-destructive and in-line inspection of aircraft composite parts contributes to efficient high-volume aircraft production, such as expected for the next-generation short-medium range (SMR) aircraft with entry-into-service in 2035. However, automation can also be cost-effective for smaller production volumes, as it enables faster detection of […]
Construction and Manufacturing

29 April 2025

R&D case FLAPsense

Optical sensor system for real- time proprotor FLAPping angle monitoring – FLAPsense The real-time monitoring of the flapping of the rotor hub of a Next Generation Civil Tilt Rotor (NextGenCTR) aircraft enables the enhancement of the proprotor performance and operational safety. Accurate deformation and motion measurements in the rotating frame are a highly challenging task. […]
Construction and Manufacturing

20 March 2025

R&D case: Enabling temperature control for large scale additive manufacturing

The challenge One of the main challenges of Large Scale 3D printing of high temperature thermoplastics is the control of the interface temperature – which determines the degree of bonding between consecutive layers. When the deposited material has cooled down in excess, poor adhesion is achieved between layers, leading to insufficient strength, delamination, cracking and […]